Skip to main content
FreeMan's user avatar
FreeMan's user avatar
FreeMan's user avatar
FreeMan
  • Member for 9 years, 3 months
  • Last seen this week
19 votes
Accepted

When should I use a Jointer vs. a Planer?

16 votes

Miter Saw Capabilities

15 votes
Accepted

"Joint" or "Join": What is the name for the place where two pieces of wood are fastened together?

12 votes
Accepted

What are spokeshaves and what is their intended use?

11 votes
Accepted

Making fake/pseudo plugs or caps

10 votes
Accepted

Lumber crayon versus crayola...what's the difference?

10 votes

Why are table legs attached to the edge of tabletop so rare?

9 votes

Is there a procedure or equation to calculate optimal height of a seat based on a given person?

9 votes

How to bind wooden pieces together, but detachable

8 votes
Accepted

Why make loose tenons narrower and shorter than the combined mortises?

7 votes

How can I get this effect and what is it called?

7 votes
Accepted

Should I use cleats or brackets when putting up shelves?

7 votes

How to remove dust after sanding before applying paint/oil/glue?

7 votes

How do you make mortise and tenon joints using power tools?

7 votes

As an individual woodworker, how do you work with slabs that are too heavy to lift?

7 votes
Accepted

Is a featherboard necessary on a router table? Why not a block of wood?

6 votes

Problem in the shank diameter of trim router bits

6 votes

How can I trim plywood flush to an edge that is not 90 degrees?

6 votes

Using a cheap table saw

6 votes
Accepted

Are these sanding discs defective?

5 votes

Plane to produce beveled edges on plywood?

5 votes

What are the downsides of using Home Depot whitewood (spruce/pine/fir) for a sawhorse?

5 votes

How would I go about achieving a curve in wood?

5 votes

How do you pronounce dado?

5 votes

Hollowing out a piece of timber

5 votes

Why does direction matter when using an electric router?

5 votes

What technique and tools can I use to create a straight canoe pole from a green tree

5 votes

How to sharpen a circular saw or mitre saw blade

5 votes
Accepted

How to make a mitre cut along the width of a board with hand tools

5 votes
Accepted

Putting new blade on 1940's table saw

1
2 3 4 5 6