keshlam's user avatar
keshlam's user avatar
keshlam's user avatar
keshlam
  • Member for 7 years, 8 months
  • Last seen this week
  • Massachusetts, USA
25 votes
Accepted

Why are keyed drill chucks still available for modern tools?

22 votes
Accepted

What kind of fire extinguisher should I have in the shop?

13 votes

Considerations for using smaller diameter blades on table saw?

12 votes

What is a planer sled and how do you use it?

11 votes
Accepted

I was thinking of buying a router. I tried a router bit in my power drill. It didn't work

10 votes

What are some efficient and effective ways to remove rust on old hand saws?

10 votes
Accepted

How do I make a mortise and tenon joints by hand

10 votes

Are spline joints inherently stronger than a standard butt miter joint?

9 votes

What is a crosscut sled used for?

9 votes
Accepted

Is this a specific kind of hand drill?

9 votes

What is the proper place of nails in woodworking?

8 votes

What can I coat a wooden drawer slide with to reduce drag?

8 votes

What is the purpose of a saw nib?

8 votes

jointer cutter head : segmented spiral vs traditional knife design

8 votes
Accepted

How can I ensure my threaded inserts go in straight?

8 votes
Accepted

Sanding the final coat of lacquer?

8 votes
Accepted

What is a morse taper?

8 votes

Is vertical storage of sheet goods causing my boards to warp?

8 votes
Accepted

Supporting a workpiece during staining / finishing without damaging finish

8 votes

What methods could I use to round the edge of a thick board?

8 votes
Accepted

How do I choose a drill press?

8 votes
Accepted

How do I safely accomplish plunge cuts on a router table?

7 votes
Accepted

What is snipe on a thickness planer?

7 votes

Can I run a router bit over its max RPM?

7 votes

How do I know what tools I need?

7 votes

How can I cut veneer with a hand saw and not chip it?

7 votes

I wonder how this alternating stain effect is made

7 votes

What can I do if I lose the chuck key for my drill?

7 votes

When do I need to use a router table instead of a handheld router?

7 votes

When building an outdoor structure, should I use pressure-treated lumber or something like cedar?

1
2 3 4 5
7