Skip to main content
Andrei Rînea's user avatar
Andrei Rînea's user avatar
Andrei Rînea's user avatar
Andrei Rînea
  • Member for 6 years, 2 months
  • Last seen more than a week ago
10 votes
4 answers
15k views

How to clean clogged sandpaper

8 votes
1 answer
408 views

Can a bad mouth plane be saved?

7 votes
1 answer
233 views

Is it needed to have the lever cap flat against the blade in a shoulder plane?

6 votes
3 answers
2k views

How to clamp very thin wood for planing

5 votes
1 answer
171 views

What kind of plane is this?

5 votes
2 answers
975 views

How is this engraving obtained?

4 votes
2 answers
657 views

How do I clean resin residue from router bits

4 votes
1 answer
236 views

Filling large gaps

4 votes
1 answer
2k views

Joint all sides square?

4 votes
2 answers
13k views

Joint types for very thin plywood

3 votes
2 answers
572 views

White deposit in tung oil

3 votes
2 answers
5k views

Oiling and sanding

3 votes
2 answers
2k views

How to achieve a rounded edge on a thick panel of solid, hard wood

3 votes
3 answers
127 views

Does a bandsaw up 18 inches tall or smaller exist?

3 votes
2 answers
1k views

Best way to hide counter sunk screws

3 votes
3 answers
593 views

Difficulties using a marking knife

2 votes
1 answer
501 views

Stanley 78 rebate plane spur goes too deep

2 votes
2 answers
200 views

Does it make sense to own a #1 if I already have a good block plane?

2 votes
2 answers
898 views

How to add a consistent chamfer across a non-linear edge using hand tools

2 votes
2 answers
179 views

Can I use glasses-cleaning leather to make a strop?

2 votes
2 answers
409 views

Doweling technique - can they be applied in two stages?

2 votes
2 answers
3k views

Why is metal avoided when joining wood?

1 vote
2 answers
5k views

Cross cutting narrow stock using a track saw

1 vote
1 answer
2k views

What are these holes in the router base plate for?

1 vote
1 answer
1k views

Styling dovetail box - tails or pins on front side

1 vote
1 answer
777 views

What are some proper ways of doing rabbets in plywood using hand tools?

0 votes
1 answer
299 views

Remove little material from a wooden piece with manual tools

0 votes
1 answer
71 views

Tabletop inlay design sources

0 votes
0 answers
30 views

Why don't we use cross cut discs for all cuts? [duplicate]