user avatar
user avatar
user avatar
aaron
  • Member for 7 years, 2 months
  • Last seen more than 3 years ago
20 votes

Why a zero clearance insert?

10 votes

Choosing wood and finish for outdoor furniture

9 votes

Why thread both ends of a pipe for a pipe clamp?

6 votes

Does dropping boards really relieve internal tensions?

6 votes

Is dimensional lumber kiln-dried differently than a kiln-dried board meant for woodworking?

6 votes

Are mortises with angled walls cut the same way as square mortises (handtools)?

6 votes
Accepted

Create a recess that nearly traverses the wood

6 votes

pine panels with minor cupping suitable for dovetails?

6 votes

How to fix a gap in plywood screwed joint

5 votes

Can polyurethane be used outdoors?

4 votes

How to get writing out of a soft wood desk top

4 votes

Sharpening - grit progression

4 votes

How long does glue take to dry?

4 votes

What should I do to maintain a saw blade?

4 votes
Accepted

Will PVA glue add some thickness to two and more pieces of plywood?

4 votes

How to cut round corners on a 4x4?

4 votes

What wood type is suitable for a childrens toy?

4 votes

Gluing joints with no clamps

4 votes
Accepted

Ran into a few issues while staining my table top

3 votes

Can i use Aspen wood for my beginner axe handle?

3 votes

Didn't let wood dry between coats of stain & poly. How to correct?

3 votes

What is the best finish for wood in a bathroom

3 votes

Using scrapers on "fuzzy" woods

3 votes

Cutting dressed pine to make it narrower

3 votes

Finishing a narrow cavity

3 votes
Accepted

DIY Kiln Dry Walnut Plan

3 votes

What wood is best for engraving?

3 votes
Accepted

Walnut drawer sides: Is it wise to glue-in the plywood base?

3 votes
Accepted

How to Cut Dados in MDF with Hand Tools

3 votes

Can a short tusked tenon be reinforced (with dowels)?