ww_init_js's user avatar
ww_init_js's user avatar
ww_init_js's user avatar
ww_init_js
  • Member for 5 years, 8 months
  • Last seen more than a month ago
  • Vancouver, BC, Canada
10 votes
2 answers
762 views

How to handplane many boards to the same dimensions

9 votes
2 answers
2k views

How does Frank Klausz achieve a >90 turn with a turning saw without cleanup when cutting dovetails?

9 votes
2 answers
3k views

Which edge of the plane's mouth should I file if I want to open it up?

8 votes
2 answers
321 views

How to cleanup diamond plate efficiently?

6 votes
2 answers
2k views

Is shellac that has been dissolved with methyl hydrate (methanol) toxic, once dry?

6 votes
1 answer
961 views

How to make bottom face of beefy table leg flat and square with sides

5 votes
1 answer
1k views

Are Oil finishing and Oil polishing complementary?

5 votes
3 answers
1k views

Are mortises with angled walls cut the same way as square mortises (handtools)?

4 votes
1 answer
235 views

How to repair breakout at the intersection of two through-mortises (inside the joint)?

4 votes
2 answers
80 views

Making table leg slightly longer

4 votes
1 answer
465 views

Can one apply dark shellac over light shellac (satisfactorily)?

4 votes
1 answer
432 views

pine panels with minor cupping suitable for dovetails?

4 votes
2 answers
216 views

Are there square-taper drill bits larger than 1-1/2" for hand braces?

3 votes
1 answer
108 views

Should thick (softwood) joint be drawbored through and through?

3 votes
2 answers
87 views

Aligning entry and exit side of drawbores

3 votes
3 answers
576 views

What are some tricks to draw long arcs along a table apron

3 votes
1 answer
1k views

oak has vinegar smell, action needed?

3 votes
1 answer
641 views

What is the minimal spacing between edge of leg pommel and mortise and tenon apron (intersected by tusk tenon)

3 votes
3 answers
3k views

What are the best substitutes when nothing labelled as "Denatured alcohol" can be found in your area?

2 votes
2 answers
6k views

Fixing mistake: Filling the gap in a breadboard end on tabletop

2 votes
1 answer
796 views

To prepare SPF (spruce/pine/fir) tabletop before a finish: should I use scraping, planing, or sanding?

2 votes
1 answer
965 views

Fixing small knot hole in pine -- compatible with oil finish

2 votes
1 answer
294 views

Can a short tusked tenon be reinforced (with dowels)?

1 vote
0 answers
39 views

Choosing a finish for a tusk/key/wedge that stays put

1 vote
1 answer
5k views

making shellac darker / tinting shellac

1 vote
2 answers
1k views

How to treat tools immediately after de-rusting treatment (molasses)?

1 vote
1 answer
333 views

Can I avoid spur / knicker marks in dado bottom cut with plough plane (stanley #45)?