Skip to main content
scanny's user avatar
scanny's user avatar
scanny's user avatar
scanny
  • Member for 7 years, 8 months
  • Last seen more than a month ago
  • Menlo Park, CA
4 votes

How to form an indentation in wood to hold candles?

7 votes

How to mount mirror in wood frame that is not square?

1 vote

New to woodworking, appears synthetic wood(?) can't be penetrated by electric drill for adding joints

1 vote

What is this tool called?

3 votes
Accepted

Are brass plated screws sufficient to avoid black staining in oak? / Alternatives

2 votes
Accepted

Stanley 9 1/4 block plane depth adjuster interferes with lateral adjuster

7 votes
Accepted

Feed direction on a planer/thicknesser

2 votes
Accepted

Why do all soft close hinges require 1/2 inch or 12mm holes on the cabinet door?

2 votes

Any reason to add screws if I only want to use glue?

6 votes
Accepted

How do I clean resin residue from router bits

1 vote

Can I use a 12” granite block for fettling a #5 plane?

4 votes

Is the MT2 Arbor for a Drill Chuck milled incorrectly?

1 vote

Trouble flattening a #7 jointer plane

3 votes
Accepted

Reusable Desk design: how to join pieces?

3 votes

Can I fix this whetstone?

2 votes

Can all whetstones be cleaned?

0 votes

What do I need to know to use a claw hammer effectively

4 votes
Accepted

What happens to kiln-dried wood when it's exposed to moisture?

4 votes
Accepted

Seal a 4" jointer bed

1 vote

Whittling knife sharpening with Kennametal sharpening stone

4 votes

"T" joint with MDF—No power tools

2 votes

Setting precise depth on a table saw with no depth gauge

5 votes

Should I build basement shelving so it's square with the wall or with the floor?

3 votes
Accepted

Problems adjusting block plane

2 votes

How to fasten a 2x4 to a 4x4 and a floor that is 1" made of plywood

8 votes

Wired my shop to 220v, can I buy table saws rated for 230-240v?

9 votes

countersinking screws

3 votes
Accepted

How to add bookshelf to a desk without doing any permanent damage?

4 votes
Accepted

Is it ok to clamp down squares and i-beam style levels?

2 votes
Accepted

Drop-in threaded hole for screw?