user avatar
user avatar
user avatar
Jacob Edmond
  • Member for 5 years, 10 months
  • Last seen more than 3 years ago
10 votes
Accepted

How can I accurately cross-cut a board that is too wide for my table saw?

10 votes
Accepted

Can you hook up two shop-vacs in parallel to increase airflow through a dust collection system?

7 votes

How can I join two boards at the ends?

6 votes

If I mill / surface my own wood, will it warp as bad as pre-milled / surfaced wood from the store?

5 votes
Accepted

Leaving counterbore holes unfinished on exterior projects

5 votes
Accepted

ShopVac with Cyclone hoses, 2.5 or 4.0?

5 votes
Accepted

What kind of wood is thin enough to cut with a knife, but strong enough for doll furniture?

5 votes
Accepted

Is it OK to use WD-40 to clean wood?

5 votes

My contractor sanded our plywood seating... Is there any way to fix the finish?

4 votes

how to design and install full length (floor-to-ceiling) built in bookcase?

4 votes

what is a safe way to plane a cross-grain board?

4 votes
Accepted

Why did my flush trim bit chew up my work piece?

4 votes

Using right angle clamps

4 votes

How might I design a "quick-breakdown" feature to allow easy assembly and disassembly of this floating beds frame supports?

4 votes

What can I put on a wooden dowel to have a good grip?

4 votes

Looking for a type of vise that would fit on a cnc table

4 votes

Shelf made of 1x2 pine boards. Stable?

4 votes
Accepted

Pocket Hole Joint Strength

3 votes

Invisible wall mounts

3 votes

Building a safer blade guard on a table saw sled

3 votes
Accepted

No rear clearance spring assisted lid hinge system

3 votes

How to use a router to cut a thick wood board

3 votes

Homemade belt sander belts (3X18)

3 votes

Using plexiglass instead of aluminum plate for router table

3 votes
Accepted

How can I carve out an inset in butcher block?

3 votes

Ripping vs Resawing - is there a reason for the difference?

3 votes

Lumber Calculator

3 votes

FIlling up gaps in an old wooden floor

3 votes

Does the waterfall side of my table design have a strong joint?

2 votes

Safety - Cutting multiple pieces at the same time