8

Is there a better/recommended way to do this? All the methods you list are recommended ways of removing dust from the workpiece. Brushing is actually a very good way to get dust off wood, and for many woodworkers it's the main method they rely on. It's just that you usually can't do it properly with only one brush. You can use a large soft hand brush to ...


7

Your item #3 is called a tack cloth and is quite commonly used for removing dust, because, as you noted, it's quite effective, and it's a highly recommended solution. According to the linked Wikipedia article, there may be some VOC concerns, however, with increasing environmental regulations, those are either A) listed on the packaging, or B) being phased ...


6

Instead of sucking it up you can blow it away using compressed air (or just your lungs). A moist (not wet) cloth will minimize the water you apply to the wood. A micro-fibre cloth is dry but will also have a very good dust grabbing properties.


3

Recommend an intial pass with a shop vac, which will capture probably 95% of the dust. It is good to use a shop vac to clean the surface between sanding grits, removing the larger grit particles from the wood before sanding with the next higher grit. While blowing the dust off with compressed air removes the dust, it also mixes it into the air so some of it ...


3

Sorry to hear about your problem, something like this cropping up just before you're about to start finishing is the last thing anyone wants to deal with. And needless to say this shouldn't happen. Will the residue cause any problems with my finish? It depends on your finish. But for security I would want to remove it personally, regardless of what I ...


2

"Swiffer" dusters have worked well for me in the past


2

In a pinch I once used an old t-shirt lightly sprayed with hair-spray. The spray then dried on the cloth for a few seconds before use. It worked surprisingly well.


1

I like to use a soft terry cloth to wipe down before I apply finish. So far it has worked well for me in getting the fine dust off the wood. On wood with larger open grain (like padouk) I sometimes will blast it with air from the air compressor as well.


Only top voted, non community-wiki answers of a minimum length are eligible