Hot answers tagged

5

From the youtube videos I've watched it seems that the 45 degree heavy duty chamfer bit 36-950 from Infinity Tools is the go to bit for this sort of job, however it also appears that this only comes in 1/2 inch shank :-( When the cutter approaches or exceeds the cost of a new router (and perhaps it's worth mentioning that routers litter the secondhand-tool ...


4

it also appears that this only comes in 1/2 inch shank A 45° cutter that's large enough to cut the full 22mm thickness of your work will have to be at least 44mm in diameter, plus the diameter of the shaft, for a total of 51mm or more. You wouldn't want a sharpened chunk of metal that large spinning at 10,000rpm or more on a 1/4" shank. I'm just ...


1

Another possibility (which I don't think is likely, but I'm adding here for completeness) is that the kerf is closing after the cut and the material is binding the blade. The main cause of this would be that your workpiece is improperly supported. If you have auxiliary supports outside the saw itself make sure that they are level with the saw. If they are ...


1

Recently I noticed it's began sticking (stop cutting) whilst cutting and I have to raise the blade and have several attempts to finish the cut. I am only cutting pine wood. It sounds like the blade is either extremely dirty, or very dull, or both. A new blade is probably the fix you need, but you could try cleaning the one you have first to see if that ...


Only top voted, non community-wiki answers of a minimum length are eligible