New answers tagged

1

As suggested, I tried heat and moisture, and applied at the same time -- I actually have a steamer machine, so I tried blasting searing hot steam into the joint, for about 10 minutes, as I tried wiggling it a little, and using a block and hammer...turns out I applied the glue properly unfortunately, and yes Titebond is stronger than the wood itself. I was ...


0

You will most likely be able to cut through the glue with a utility knife (Ofla or similar) using a fresh blade extended so that it's an inch or so longer than the door is thick. Just hold it flush with the wood on one side, angled slightly inwards, and push down hard -- use a slight sawing motion if necessary. You will cut right through the glue, it's ...


4

This is going to be tricky, since glue joints are stronger than the wood. So be prepared for at least some breakage to occur. If you can get to work immediately there's a chance of working on the glue before it's completely cured, although overnight drying is enough for almost full strength with most glues of this type in most conditions. You're going to ...


Top 50 recent answers are included