Questions tagged [tabletop]

Use for any Question regarding tabletops, including creation and maintenance.

Filter by
Sorted by
Tagged with
9
votes
2answers
4k views

Stabilizer for softwood tabletop that bows

I am building a cheap dining table out of cedar 2x4's. This is obviously not my first choice for wood but money was my limiting factor. I have planed them down to size and biscuit joined them together ...
6
votes
2answers
1k views

Thick tabletop movement

I'm going to build a large table and my customer wants the top 3" thick. My plan is to use wide boards(8"+). So I have some concern about cupping but figure that might not be as much of an issue with ...
7
votes
3answers
12k views

Do pocket hole screws allow for proper expansion and contraction in planked table tops?

I am learning furniture building. I started by building tables using pocket hole screws to attach the planks together and also to attach the table top to the apron/base. I am now converting to using ...
-1
votes
1answer
974 views

horizontal stability of a table

I'm making a table and I wonder how to improve the horizontal stability so that the table does not wobble/move from left to right. Here are the details: The table width is 160cm, depth 70cm, height ...
8
votes
2answers
11k views

Make a table top using pocket holes?

I want to make a table top from some oak planks that I have. The oak is about 1" x 6" x 8' each. Is using pocket holes and glue an appropriate method for edge-joining the planks together to make the ...
6
votes
2answers
2k views

Panel Flatness During Table Top Glue Up

I recently attempted a panel glue up consisting of 7 2"x6"x6' planks of reclaimed yellow pine. The boards were planed flat on one side and edge jointed. All went well it seemed during the glue up (i.e....
5
votes
3answers
4k views

How can I create a planked wood table top with a plywood core?

I was looking at this table made by Harp Design company Melissa Table The description describes the top's construction as: Each top is crafted from reclaimed old growth pine which is planed down ...
6
votes
3answers
6k views

How to attach table legs to wood that is too thin?

I'm trying to attempt to make use of some wood that I've got and turn it into a table. I've looked everywhere for table legs which I can screw into the wood but every table leg I see needs a minimum ...
5
votes
3answers
385 views

Table top attachment with aprons on only two sides

I'm building a small computer/writing desk. It will have a solid top, so I'm figuring out how to attach it to the frame to allow for wood movement. I planned on using tabletop fasteners (Z clips), ...
4
votes
1answer
554 views

Best method to attach an edge board to an end-table top board

I'm making a end-table topper out of 1 3/8" butcher block for over the top of a subwoofer. I posted a question about how to route out the center of a board. It was determined that although it is ...