Questions tagged [table-saw]

About uses and techniques, features to look for etc.

8 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
0answers
119 views

What are the holes on my table saw table for?

I recently scavenged a broken Ryobi cheap table saw from the curb (somehow the motor had been broken off at the arbor end!) Got a much better fence than the broken plastic one on my cheap import table ...
1
vote
0answers
98 views

10 inch blade instead of 12 in

I could use some insight, please. I have a Craftsman 220 table saw. Trying to find a 12in blade with a 5/8s hole is an arduous task. Can I use my 10 in blades with this saw?
1
vote
0answers
107 views

Info on 1980's Black and Decker contractor saw with rack & pinion fence?

I was wondering if anyone has ever owned/ heard of a Black and Decker Contractor Table Saw with a rack and pinion fence, released sometimes in the 80's. My dad told me about these saws but I would ...
1
vote
0answers
214 views

How can I cut a custom height wooden door threshold? Table saw & planer

I have a piece of 2x8 redwood, and need to make a threshold for the following inswing door configuration: The door is exterior inswing with no overhang at all (Mediterranean style home). I have ...
1
vote
0answers
213 views

Home made table saw + home made scoring blade

Can angle grinder be used as motor for scoring blade? What I have found so far the rotation speed should be pretty similar and regular scoring blade can be probably also fitted on the grinder.
1
vote
0answers
118 views

Unwanted change of depth of cut

I have a Jet 10" 708325 table saw. I set the depth of cut, but the blade lowers itself after a couple of cuts. I do not see anything in the manual addressing any adjustments.
0
votes
0answers
95 views

DIY table saw installation

I am resurfacing my workbench with 25mm hardwood ply. I am inverting an up/down router and tablesaw into it (between tracks). I want to use thinner insert plates (for the zero clearence saw and so ...
0
votes
0answers
285 views

Advice on my Delta Unifence?

My Unifence handle is not staying down/engaged. It’s somehow to do with the handle/cam lever and/or thrust washer and/or…? If I hold itin position/down the fence locks tight in place as it should...no ...