Questions tagged [table-making]

Use for all aspects of table making and all types and sizes of table.

Filter by
Sorted by
Tagged with
7
votes
3answers
13k views

Do pocket hole screws allow for proper expansion and contraction in planked table tops?

I am learning furniture building. I started by building tables using pocket hole screws to attach the planks together and also to attach the table top to the apron/base. I am now converting to using ...
-1
votes
1answer
1k views

horizontal stability of a table

I'm making a table and I wonder how to improve the horizontal stability so that the table does not wobble/move from left to right. Here are the details: The table width is 160cm, depth 70cm, height ...
6
votes
2answers
2k views

Panel Flatness During Table Top Glue Up

I recently attempted a panel glue up consisting of 7 2"x6"x6' planks of reclaimed yellow pine. The boards were planed flat on one side and edge jointed. All went well it seemed during the glue up (i.e....
5
votes
1answer
882 views

Best way to attach metal legs to corner desk? Do I need extra support?

I'm making my own office desk, I'm 2m04cm so the height and depth are appropriate. I've made the desk top from reclaimed floorboards. It's 1 inch thick, the supports underneath are from the same ...
5
votes
3answers
5k views

How can I create a planked wood table top with a plywood core?

I was looking at this table made by Harp Design company Melissa Table The description describes the top's construction as: Each top is crafted from reclaimed old growth pine which is planed down ...
6
votes
2answers
10k views

What is the strongest join for splayed legs?

I intend to make a splayed leg dining room table similar to the ones in these images: Because dining room tables typically support a good deal of weight, I'm concerned about the amount of stress ...
6
votes
3answers
6k views

How to attach table legs to wood that is too thin?

I'm trying to attempt to make use of some wood that I've got and turn it into a table. I've looked everywhere for table legs which I can screw into the wood but every table leg I see needs a minimum ...
5
votes
2answers
36k views

How do I stop the table I built from wobbling/shaking side to side?

I got a wood cut and bought adjustable table legs, secured the legs to the wood, but the table wobbles/shakes horribly side to side, and sometimes even the other way when i even only write something ...
4
votes
1answer
573 views

Best method to attach an edge board to an end-table top board

I'm making a end-table topper out of 1 3/8" butcher block for over the top of a subwoofer. I posted a question about how to route out the center of a board. It was determined that although it is ...
0
votes
1answer
169 views

horizontal stablity [duplicate]

I'm making a table and I wonder if it will be horizontally stable. Here are the details: The table width is 160cm, depth 70cm, height 76cm. The table top is 6cm thick and is made out of block-board (...