Questions tagged [steam-bending]

The process of using steam to soften wood to bend it into shapes.

Filter by
Sorted by
Tagged with
8
votes
1answer
108 views

Can I steam-bend a piece of wood with a free-floating end?

I've been working on creating a wooden hockey stick. The blade of the hockey stick needs a slight curve and bend to it. I have a small steam box set up and have created a vice with different-length ...
8
votes
1answer
1k views

Steambending Softwoods

I have read that there are only two softwoods that steambend well, Pacific Yew and Alaskan Yellow Cedar. Are there any other softwoods that have steambending properties that are comparable to the ...
2
votes
3answers
164 views

Will gluing thin planks to cut out curved chair leg be strong?

I'm making an armchair for a child. I want the back leg to be straight-vertical at the seat level but kick back down the floor, and lean back at the, erm, back. Much like every other rear chair leg in ...
2
votes
2answers
948 views

Creating a hollow, seamless box; CNC needed?

I'd like to create a seamless box from nice wood, which is hollow and has rounded corners. It should be comparable with the clock on the left, but with rounded corners like on the right. It needs to ...
2
votes
1answer
1k views

Remove twist from plank without reducing thickness

I have a 5/4" x 8" x 6' plank of cherry with a twist on one end. The twist is only about 18" long. When you lay it on a flat surface the corner was raised about 1/4". I tried soaking the board in my ...
1
vote
1answer
68 views

Bending Wood: is it easier to bend fast or slow growing ash

I want to bend ash for the stem of a canoe. I am trying to select straight grained quarter-sawn pieces. Should I select pieces which have faster or slower growing wood?
1
vote
0answers
2k views

Is it possible straighten (unbend) a piece of coconut shell. Steaming it or heating it?

Is it be possible straighten a piece of coconut shell using similar techniques to bend wood? I know it's not wood but I just can imagine cutting the coconut shell in many tiles and later straighten ...
0
votes
1answer
293 views

How to build an effective steam box?

I have built a steambox as shown above, out of plywood. I'm trying to bend some Pinus elliotii (slash pine) as a test with it, but it has not been effective. I have left it on for thirty minutes with ...
0
votes
1answer
466 views

Can you effectively correct a warped board finished with polyurethane (or other waterproofing)?

Heat and moisture tend to be the go-to's for effectively bending wood. Because of the finish, not much, if any moisture will be able to penetrate the wood. Can heat alone, or just a solid rig that ...
0
votes
4answers
69 views

Recommendations for a 3’ diameter wooden pipe?

total amateur here. I’m trying to figure out some options for building, essentially, a pipe with these attributes: 3-inch walls (can be hollow) inner diameter of about 3 feet length of this tube/pipe/...
0
votes
2answers
120 views

How do I fix this part of my desk?

I got this desk from a friend that rescued it from the dump. There's a lot of rescue efforts that I'm putting into it. Not the least is fixing the finish that's totally gross. I started scraping the ...