Questions tagged [router]

Routers and bits, features, techniques, safety etc.

9 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
6
votes
0answers
161 views

Routing out recess for base plate - router table

I want to make a mini router table. The base material is a type of birch plywood with 15 layers or so, 21mm thick. Well if the dictionary serves me right, it's actually called "textured coated board" ...
3
votes
0answers
59 views

CNC-Vcarve: 45° Bevel on 3/4" Board with 1/2 v-Bit

I'd like to put a 45° bevel (miter) on one edge of a 3/4" board with a 1/2 " 90° V-bit I already own. This seems like it should be possible, but I am having issues 1) figuring out myself; or 2) ...
2
votes
0answers
103 views

How do I use this adapter for a router bit with an M10 internal shaft?

I purchased a Mafell hand router (model LO 65 Ec) and it came with this adapter: The top (narrow end opposite the threaded male) has some sort of female hex socket. Where are female threaded router ...
2
votes
0answers
73 views

Plunge router base plate has a bit sticking out - why?

I just got a router and there's a plate on the bottom (required for the dust extractor attachment) which has a hole in it with a raised circular wall that protrudes beyond the level of the base. Is ...
2
votes
0answers
304 views

Trim / Casing and Baseboard choices between rooms

I understand this is partially design, however I think it's part of the art of fine trim carpenters. This is my second floor sitting room which has routed 1x8s as baseboard and 1x6 with the same ...
1
vote
0answers
95 views

Spindle moulder blocks and cutters

I have just purchased an old Tyzack spindle moulder (shaper) and need some help please. I'm new to carpentry and have never used a spindle moulder before. I am in need of a block and cutters. I ...
1
vote
0answers
59 views

Reducing collet 3/8“ - 1/4”

I picked up a relatively cheap plunge router that takes 3/8" however I can't seem to find any reasonably priced 3/8" shank bit kits. I have found 1/4" and obviously it doesn't fit. Is there an ...
1
vote
0answers
53 views

Ridgid palm router microadjustment drift

I had to surface some boards, and Woodworld is having classes this week so they can't get to it. This seemed like a good opportunity to use some parts I had from a CNC build a few years ago, so I ...
1
vote
0answers
48 views

Curved stairway re-do

newbie here. I'm about to tackle rebuilding the 180 degree curved, plywood/carpeted stairs in my home with solid 3/4" oak treads and painted hardboard risers. My question has to do with cutting the ...