Questions tagged [router-bit]

Partnered with a router are used to profile wood. Wide selection of bits makes for interesting patterns.

4 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
6
votes
0answers
161 views

Routing out recess for base plate - router table

I want to make a mini router table. The base material is a type of birch plywood with 15 layers or so, 21mm thick. Well if the dictionary serves me right, it's actually called "textured coated board" ...
2
votes
0answers
103 views

How do I use this adapter for a router bit with an M10 internal shaft?

I purchased a Mafell hand router (model LO 65 Ec) and it came with this adapter: The top (narrow end opposite the threaded male) has some sort of female hex socket. Where are female threaded router ...
1
vote
0answers
59 views

Reducing collet 3/8“ - 1/4”

I picked up a relatively cheap plunge router that takes 3/8" however I can't seem to find any reasonably priced 3/8" shank bit kits. I have found 1/4" and obviously it doesn't fit. Is there an ...
1
vote
0answers
55 views

Most efficient bit characteristics for 1-1/4hp router.

I have a 1-1/4 hp router that only has a 1/4" collet. Assuming I want to hog the deepest widest dado possible in one cut, what characteristics do I want? Put aside buy a bigger router arguments for ...