Questions tagged [installation]

The conditions, techniques and issues associated with placing completed woodworking projects in place such as cabinetry in buildings.

Filter by
Sorted by
Tagged with
2
votes
3answers
177 views

Monolithic wooden boards vs joint wooden boards

We are going to make modular kitchen and wardrobes for our home using pure hard wood like teak wood. The depths of the shelf vary from 1 feet to 1 and half feet. For shelves, can we use planks of ...
0
votes
1answer
138 views

Thickness of back-panels, horizontal planks and vertical planks

Our walls are made of Reinforced Cement Concrete (RCC) with a thickness of 15 cm. The walls have 15mm gypsum plaster on both the sides. We are doing interior design - installation of wardrobes and ...
1
vote
1answer
54 views

Hinge pin problem in installation

First of all, I'm fully aware that, this is a very simple question. but I can't find the solution. I want to make the foldable leg for a table like this : so I cut top and bottom of each leg 10 ...
2
votes
1answer
100 views

Are there any non obvious (specifically structural) concerns to building a walk-in wardrobe

So, I'm pretty new to woodwork but ambitious. I have an ugly wardrobe space I want to turn into a walk in. So the plan is to pull down the plasterboard wall, create a new one at the end of the ...
1
vote
3answers
157 views

how to design and install full length (floor-to-ceiling) built in bookcase?

I'm planing on using live edge boards for the sides of a floor to ceiling bookcase, and I would prefer not too use a "header" board (for lack of better term) or any sort of trim around the top or ...