5

My table top is made out of ash. There were a few spots that didn't take the stain well. Any suggestions on how to approach fixing these spots? This is my first build, so any help is appreciated! enter image description here enter image description here enter image description here

  • 2
    It's not the question you asked, but, seeing how you put that table top together, framing it with rails that extend all the way to the ends lengthwise, I'm nervous about how this design stands up to wood movement. Look into "breadboard ends," and especially why they are used. You can see what they are an a little about them here: woodmagazine.com/woodworking-tips/techniques/joinery/breadboard – Katie Kilian Jul 31 '17 at 14:56
  • I think that is glue residue; guessing you tried to rub it off w/ a wet rag or something during glue up. You gotta get that out for the stain to take evenly. You can get away with some glue residue if you are not staining, but any glue residue will really show w/ a stain. Take it down a couple mm at least because it does penetrate some into the wood. – jbord39 Jul 31 '17 at 22:50
  • 1
    +10 on the Comment above from @CharlieKilian, you will get some issue down the line, guaranteed, if the battens on each end are firmly glued in place along their whole length (or attached with pocket screws). There are a couple of previous Q&As here on this you want to read a bit more on the subject. – Graphus Aug 1 '17 at 5:48
4

There was definitely some sort of surface contamination that prevented the stain from absorbing evenly. The only way to make it even, aside from painting, is to remove all of the current stain by planing, scraping, or sanding, and restain. The good news is, as long as you don't spill anything on the surface afterwards, you will have removed whatever contamination caused this.

| improve this answer | |
  • 1
    looks like glue to me – jbord39 Jul 31 '17 at 21:46
  • Great, thanks, I'll give it a shot. We used glue between the boards but there wasnt much leakage. – Matt Altepeter Aug 1 '17 at 2:07
  • 1
    @MattAltepeter Did you wipe away the excess glue when it was wet, wait for it to get rubbery or scrape off when dry? If you did it wet it's very easy to get this sort of issue unless you use a damp cloth (ideally using warm water, not cold) and are very thorough with the wiping. – Graphus Aug 1 '17 at 5:45
  • It was still wet, but we did use warm water, must have not been thorough enough. – Matt Altepeter Aug 10 '17 at 15:51
  • We ended up just sanding the entire thing down and attempting to stain again. We had much better results the second time around – Matt Altepeter Aug 10 '17 at 15:55

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.