3

This is a continuation from my previous question on the log box I've been carving. Since then I've carved the handle (thanks for the advice!) and added a magnet closure system for my swivel lid (neodymium rings fastened in place with aluminum nails).

See the pictures below for a look.

I feel like I've got the exterior where I want it to be, but I'm having trouble finishing the cavity to a level where it's visually "clean." I've been working it mainly with hand tools and my Dremel. The interior cavity is roughly 4.25" deep and a about 3.25" across, which means the narrowness limits the work space.

Will I have to spend an eternity sanding, or is there another way to work out the tool marks?

Side profile with view of handle carved out Top down picture of the closure system and rough interior

3

This is probably going to be tough any way you cut it. I would suggest a combination of curved card scraper and something like these abrasive brushes, possibly mounted on a long or flex shaft to get into the cavity.
Abrasive brushes from Amazon

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.