10

I was liberating some old hand tools from my grandfather's shop again, before grandma throws them in the garbage, and found some more interesting things. This time I am sure that this one is a woodworking tool!

enter image description here

It looks like a tool that's a tapering tool that could be used to make tenons on chair legs or something similar. It seems clear that it is meant to be used in a brace. Seems hard to try and cut a tenon though as I would think the tool would easily drift.

Following is the only markings on the tool as well as a view from the bottom that shows the blade.

enter image description here

What do you think this is called and more importantly what is it used for?

  • 1
    I don't recognize the tool, but I applaud rescuing ... You might tell your grandma that there are people interested in buying tools generally and sometimex old tools in particular even if some restoration is needed. A good hand-tool should stay in use until it is completely worn out, which can be genetations. – keshlam Feb 17 '16 at 15:28
  • Thought: Tenion cutter? – keshlam Feb 17 '16 at 18:17
  • 5
    I can't comment on the tool either, but Exchange 5.5? – PeterK Feb 17 '16 at 18:25
  • 1
    (If it was me, I'd rescue the whole workshop first and sort it out later.) – keshlam Feb 17 '16 at 20:45
  • 6
    @PeterK I needed to find a book I would never open to use as a monitor stand. – Matt Feb 18 '16 at 2:07
12

Hollow auger

U.S. Patent 203,384 is for a "Hollow auger" or more specifically for improvements to a hollow auger. "What's a hollow auger?" you ask. Well, as @Keshlam suggested it is a device for cutting tenons on chair rungs or spokes as demonstrated by a similar device on a You Tube video. It's a device that, rather than drilling a hole, it drills what fits into a hole.

The patent claims that the improvement is that this version of the hollow auger is adjustable so as to "obviate the necessity of using a separate auger for each sized tenon."

I will leave it to @Matt to figure out exactly how this one works, but it will require a brace for turning the cutting mechanism and a vice for holding the workpiece.

With tongue in cheek, I suggest that this device might also be an answer to my question from several months back: How can I make my own dowels?

  • Good research pointer! – keshlam Feb 18 '16 at 9:34
  • I found his out as well when I Google'd the patent number on the base. Was going to answer today if no one else did. Good work – Matt Feb 18 '16 at 13:30
  • This tool would not be good for making dowels though. Tenon yes but it can only cut in a few inches – Matt Feb 18 '16 at 13:31
  • 1
    @Matt Short dowels it is! – FreeMan Feb 24 '16 at 21:18
2

This tool is a tapering tool for chair, or table legs.

How to use:

With the leg in a vise, square end to one side, the tapering tool is brought slowly and carefully (adjusting from the square end) down to the foot end one layer at a time. It is adjusted using an adjustable hand wrench.

I am old-school (75 years old) and I used this tool when I was a youth of 12 years.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.