1

Whilst pinning three layers of oak sleepers together with oak dowels, I have managed to get the 25mm diameter auger drill bit stuck.

Is there any oil or lubricant that I can use to try and release the drill bit?

Of the 300mm drill cutting depth, about 200mm is within the sleepers.

On previous holes it snagged but I managed to free it to finish the hole as needed, either by winding it anticlockwise with a spanner, or pulling up with the drill whilst turning.

Appreciate whatever help or suggestions anyone can offer.

3
  • "Is there any oil or lubricant that I can use to try and release the drill bit?" This does not have a high likelihood of success, but if you want to try it (in addition to other suggestions) WD-40 might be your best bet, and you may have a can already.
    – Graphus
    Apr 20, 2021 at 1:20
  • Couple of questions for future reference, what drill bit are you using? And were you using a corded or cordless drill?
    – Graphus
    Apr 20, 2021 at 1:21
  • @FreeMan no idea. Maybe I thought I was commenting on another one, or misunderstood this one.
    – user5572
    Apr 28, 2021 at 13:12

2 Answers 2

4

It seems that your pieces of wood have shifted somewhat since you started drilling.

If you can eyeball the 3 pieces to see which one(s) seem out of line, use one or more clamps to persuade the wayward one back into position. Once you have lined them back up, you should be able to get the bit out and, without removing the clamps, drive your dowel into the hole.

As an alternative, you could put the drill back on the bit and give it a spin*, and that should cut the sides of the hole to line up with its edges again. Once you've cut the edges of the hole, the bit should come out again. Note that if you do this, you will have at least one elongated hole and when you put the dowel back in, that elongated hole will allow that one piece of wood to remain out of the desired original position.

Whether or not it matters if the 3 pieces are out of alignment when pinned will probably be determined by how much finishing work you're doing after the pinning is done, and how far out of alignment the pieces are.

*If your drill bogs down and won't spin the bit because of the tension of the misaligned wood, you may need to use a long handled wrench to turn the bit, instead. If you have a hex-shafted drill bit, a 1/4" box wrench (spanner) should grab hold of it just fine. Since those tend to be small, a bit of pipe over the other end of the wrench should allow you to generate plenty of torque to turn the bit. If it's a round-shank bit, you may need to use a pipe-wrench or monkey-wrench, however, the serrated teeth, which give you a better bite, may dig into the shank and damage it. Caveat emptor.

3

Thanks for the comments and suggestions all.

I fed some linseed oil down the auger bit and using an adjustable spanner (with a long handle for leverage) was able to turn the bit anticlockwise. The more I turned, the easier it became thanks to the oil. I reattached the drill and whilst activating the drill, and was able to pull the bit free from the jam and remove the bit completely.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.