Timeline for Wood warps after milling
Current License: CC BY-SA 4.0
11 events
when toggle format | what | by | license | comment | |
---|---|---|---|---|---|
Nov 16, 2021 at 14:07 | comment | added | gnicko | @VolframK - Yep... and it works perfectly every time.... got it. | |
Nov 15, 2021 at 6:07 | comment | added | Volfram K | @gnicko but point of milling is to take out distortions in rough material! esp using the big power tools this should be v hard, the jointer should take out 1/2 of twist even before the planer is used . | |
Nov 15, 2021 at 2:20 | comment | added | gnicko | @VolframK - No it isn't... I've done it lots of times.... | |
Nov 9, 2021 at 6:29 | comment | added | Volfram K | @BrianThompson but how did you flatten 1st face of this board, and then make final thickness? Very hard to keep twist :) | |
Nov 8, 2021 at 16:35 | comment | added | Brian Thompson | As the OP of the linked question, I'll say I'm almost certain the board was twisted before milling and I just missed it. Some other boards in the project were as well, but I was able to take it out with a planer sled. They have remained flat. | |
Nov 4, 2021 at 8:44 | comment | added | Volfram K | @Caleb so? rouch wood rarely is 100% flat, we make flat boards from it. | |
Nov 3, 2021 at 6:16 | comment | added | Caleb | Note that the OP in the original question suggests that the twist might've been present in the rough piece ("I should have caught it sooner"). So the issue there may not have been distortion during/after milling, but rather distortion during the drying process before final milling. | |
Nov 3, 2021 at 6:04 | vote | accept | Volfram K | ||
Oct 31, 2021 at 17:17 | history | became hot network question | |||
S Oct 31, 2021 at 9:15 | answer | added | Volfram K | timeline score: 5 | |
S Oct 31, 2021 at 9:15 | history | asked | Volfram K | CC BY-SA 4.0 |